Table of Contents
Advertisement
BrinksKeyPadPrinterSprd.2.22.06
User Codes
When the system is installed, you select a code number to turn the system on
and off. This is your master user code, and it may be three or four digits long.
To change this code, contact Brink's Customer Care at 1-800-445-0872.
You can create a separate auxiliary user code for anyone who needs access
to your home. See page 22 for more information. You can change or delete
the auxiliary code whenever you like.
If you have questions about the system's user codes, visit our website or
contact Brink's Customer Care.
Entering and Exiting
Designated Doors
The designated entry/exit doors are those doors that you must use to enter
and leave your home while the system is on. These doors may be equipped
with the door sensors described on page 5. If you use a different door to enter
your home, an alarm may sound.
Entry Delay
When you enter your home while the security system is on, the keypad emits
a tone. This tone reminds you to turn the system off. You must enter your
user code before the tone stops. In most systems, the entry delay is 40
seconds. If you do not enter your code before the delay ends, an alarm is
triggered.
Exit Delay
When you turn the system on in normal mode, you must exit the building and
close the door before the exit delay ends. For most systems, the exit delay is
80 seconds. That number may vary, however, if local agency or regulator
restrictions apply. Once that delay has ended, you will trigger an alarm if you
open a protected door or window, or move past a motion detector.
Note: The length of the system's entry and exit delays can be adjusted
(within certain limits). If you find it difficult to enter or exit your home before
the delay ends, contact Brink's Customer Care at 1-800-445-0872 to have it
changed.
2/22/06
3:06 PM
Page 36
12
Note: If the system appears to have no power (the keypad does not light or
respond to your commands), call Brink's Customer Care at 1-800-445-0872
for assistance.
To replace the battery in the grid extender
Unscrew the grid extender from the wall outlet and
unplug the grid extender. Slide open the rear door by
sliding down. Unplug the small connector plug that
connects the battery pack to the grid extender, and
replace with Ingrid battery model IG180, 3.6V.
To replace the battery in the keypad
The screen on the keypad will indicate "LOW BATT".
On the side of the keypad you will see a slot that is
the side of the door to the battery compartment.
Simply place a coin in the slot and turn to pop the
door open. Unplug the small connector plug that
connects the battery pack to the keypad and replace
with battery model IG180, 3.6V.
To replace the battery in a sensor
If the keypad is indicating that a sensor's battery is low, call Brinks Customer
Care at 1-800-445-0872 for assistance. The sensor battery cannot be
replaced.
33
Hide quick links:
Advertisement
Table of Contents
