System Options; How To Bypass A Zone - BRINKS BHS i 100 User Manual

BrinksKeyPadPrinterSprd.2.22.06
How to Delete an Auxiliary Code
If you wish to delete an auxiliary user code, do the following:
TROUBLE
ALARM
CANCELED
CALL
1. Press the OPTIONS key until the message window
displays: AUXILIARY CODES, ENTER MASTER
CODE.
AUXILIARY
CODES ENTER
MASTER CODE
2. Enter the master user code.
The keypad beeps. The message window displays:
ENTER USER #.
3. Enter the number of the user whose code you wish
to delete.
USER NUMBER
The keypad beeps. The window displays: ENTER
NEW CODE.
4. Do not enter the user's code. Instead, press the
CANCEL key.
The keypad beeps.
5. Test that the code has been deleted by attempting
to turn the system on and off, using the deleted
code.
2/22/06 3:06 PM Page 54
NOT READY ALL ON INSTANT
DOOR CHIME NO AC MOTION OFF
TEST LINE CUT LOW BATT
MEMORY AUXILIARY CODES
USER : I : I :
BYPASS ENTER MASTER
800-445-0872 ZONE : I : I :
NEW CODE
24

System Options

The system has five options:
1) bypass
2) door chime
3) auxiliary codes
4) alarm memory
5) test
This section describes each of these five options.

How to Bypass a Zone

When you bypass a zone, the system ignores it. Use this whenever you want
to turn the system on, but leave a particular sensor off. The bypass is
automatically canceled when you turn the system off.
To bypass a zone, do the following:
TROUBLE
ALARM MEMORY
CANCELED
CALL 800-445-0872
1. Press the OPTIONS key until the message window
displays: BYPASS, ENTER ZONE #.
BYPASS ENTER
ZONE #
2. Enter the number of the zone you wish to bypass.
The keypad beeps. The message window displays
READY, BYPASS. The number of the bypassed
zone lights momentarily.
21
NOT READY ALL ON INSTANT
DOOR CHIME NO AC MOTION OFF
TEST LINE CUT LOW BATT
AUXILIARY CODES
MASTER USER : I : I :
BYPASS ENTER
ZONE : I : I :
NEW CODE
ii