Table of Contents
Advertisement
BrinksKeyPadPrinterSprd.2.22.06
Turning the System Off
Turning the System Off When No Alarms Are In Progress
1. Enter through a designated entry door.
The keypad sounds a tone to remind you to turn the
system off. The ON light blinks.
2. Turn the system off by entering your code.
To prevent an alarm, you must enter your code
before the entry delay ends. The standard delay
is 40 seconds.
Once the system is off, the ON light goes out.
Turning the System Off and Canceling an Alarm
Follow these instructions if you caused an alarm accidentally.
1. Enter through a designated entry door.
The siren is sounding and the ON light blinks. The
keypad's message window displays ALARM.
2. Enter your user code.
The keypad beeps. The keypad's message window
displays ALARM MEMORY.
3. Press the CANCEL key. (You must press the CANCEL
key within 20 seconds of entering your code.) The
keypad beeps.
You will not receive a call from Brink's. The keypad's
message window displays ALARM CANCELED.
Note: If you press the CANCEL key before entering your code, the result is the
same.
2/22/06
3:06 PM
Page 48
18
Testing the Smoke Detector
The smoke detector can be tested without sending an alarm signal to Brink's
Monitoring Center. Call Brink's Customer Care at 1-800-445-0872 for
assistance. Do not attempt to test the smoke detector with heat, flame, or
canned smoke. These methods can damage the smoke detector.
Testing the Doors and Windows Only
This test identifies whether the sensors on your home's protected doors and
windows are operating properly. You may prefer to conduct this test if you find
it distracting to hear the siren blast each time you pass the motion detector
during the test. No alarm signals are sent to the Brink's Monitoring
Center.
To test the system's door and window sensors, follow the instructions on the
next page. NOTE: If the system's chime feature is on, skip steps 2 and 3
of the keypad instructions. When the chime feature is on, the keypad beeps if
configured to do so and the grid extender can beep if configured when
prompted using the door chime feature if a protected door or window is
opened while the system is off.
27
Hide quick links:
Advertisement
Table of Contents
