Turning The System On With Motions Turned Off / Instant Mode; Turning The System On In Instant Mode - BRINKS BHS i 100 User Manual

BrinksKeyPadPrinterSprd.2.22.06
Trouble Messages
You will get a trouble message if the system loses power, if it cannot reset the
smoke detector, or if it cannot contact the monitoring center.
1. Observe which of the keypad's icons, numbers or words are
displayed, and note any letters that may appear in the numeric
display. Match the keypad's message to the table below, then turn
to the section listed in the table's second column for further
information and instructions.
Message
CALL 800-445-0872
CF TROUBLE
CP TROUBLE
CS TROUBLE
CH TROUBLE
LINE CUT
LOW BATT
NO AC
TROUBLE Zone # (Beeping) Zone Trouble Indication
TROUBLE OP (Beeping)
2/22/06 3:06 PM Page 42
Trouble Condition Page
Call Brink's Indication 36
Component Failure Indication 36
Communication Problem Indication 34
Siren Failure Indication 36
Upload/Download Failure 35
Line Cut Indication (optional feature) 35
Low Battery Indication 32
No AC Power Indication 31
36
36
Zone Trouble Indication
30

Turning the System On with Motions Turned Off / Instant Mode

1. Close all of the doors and windows and make
sure that the message window displays READY.
(If not, see page 16.)
2. Press the ON key.
3. Press the MOTION OFF key.
4. Press the INSTANT key.
The ON light turns on. The keypad displays ON,
MOTION OFF, and INSTANT.
Do not leave the building, or open any
protected windows without first turning the
system off.

Turning the System On in Instant Mode

1. Close all of the doors and windows and make
sure that the message window displays READY.
(If not, see page 16.)
2. Press the ON key.
3. Press the INSTANT key.
The ON light turns on. The keypad displays ALL
ON, INSTANT.
Do not leave the building, open any
protected windows, or move in front of the
motion detector without first turning the
system off.
15