Adding Auxiliary Codes; Deleting Auxiliary Codes; Viewing Alarm Memory - BRINKS DCU-500 Manual

ADDING AUXILIARY CODES

This feature allows you to add up to six extra codes to turn the system on
and off. You can use auxiliary codes when you want to allow someone
access to your home, but you do not want to give them your master code.
For example, auxiliary codes can be given to houseguests, housekeepers,
housesitters, etc.
1. Press and hold the "3" key for 3 seconds.
2. Enter the user master code.
3. Press 1-6 (You have six "slots" in which to program auxiliary codes.)
4. Select 1 as the user identification for the first auxiliary code you
choose. (The next auxiliary code user identification would be 2,
and so on, up to a maximum of six auxiliary codes.)
5. Enter any user code of your choice.
6. The keypad will beep to confirm the system accepted the new
code. You may test the code by turning the system on and off
with the new auxiliary code.

DELETING AUXILIARY CODES

1. Press and hold the "3" key for 3 seconds.
2. Enter the user master code.
3 Enter the user identification number (1-6) for the auxiliary code
you wish to delete.
4. DO NOT ENTER THE AUXILIARY CODE; instead, press
CANCEL to delete the code.
5. You will receive a confirmation beep from the keypad.
6. You may verify that the code was deleted by turning the system
on and trying to turn it off with the code you deleted. If it was
deleted, it will not turn the system off.

VIEWING ALARM MEMORY

1. Press and hold the "4" key for 3 seconds.
2. The zone number of any alarms in memory will light up for 5
seconds then reset.
12