5. 4BOperation
5.1. Overview
5.1
Overview
Display modes
The sensor has the following display modes.
•
Test. Appears briefly after power-up to self-test the display.
•
Connection status. Appears when sensor is not fully connected to the OneWireless network. See
section 5.2.
•
PV display. Default mode of the sensor displays the PV and any status messages. See section 5.3 on
page 23.
•
Quick view of sensor identification parameters. Displays read-only parameters then returns to PV
display. See section 5.4 on page 26.
•
Menu. See section 5.5 on page 28.
Authentication Device
To navigate the sensor displays and menus, remove cover and hold the Authentication Device no more
than 6" from the sensor and aim the infrared beam at the sensor display while tapping the Device Local
Configuration buttons (Table 12). You can also use the PDA's buttons.
Authentication Device menus are described in section 5.6 starting on page 29.
22
OneWireless XYR 6000 Wireless Valve Position Sensor User's Manual
5. Operation
Figure 8 IR Sensor Locations
Revision 1
1/15/09