Operation; Operating The Socket Switching Module Manually; Controlling The Socket Switching Module With The Hometronic Manager - Honeywell HS 20 Operation

Operation

Operation
Exceeding the maximum connected load* can destroy
the switching module.
Caution!
►
Insert the device into the socket switching module.
►

Operating the socket switching module manually

In order to switch plugged-in devices on or off, press briefly on the
button of the socket switching module. The switching state is
displayed by the built-in LED.
• LED on = Device on
• LED off = Device off
Controlling the socket switching module with the
Hometronic Manager
Various operating modes of the socket switching module are possible
with the Hometronic. You can use the "Presence simulation" function
for example to repeat the operation course of the last 7 days. With the
"automatic brightness control" function, lamps or devices are
controlled via the brightness of an installed sun module HB 05/HB 15.
However, this operating mode only makes sense if, e.g. a lamp, radio
or similar devices are connected to the switching device.
For further information please read in the "Operation" chapter in the
Hometronic Manager instructions.
14
Fuse the switching module with a maximum of 16 A.