13. Type:
FORMAT
1
and do a Shift+CR/DEL.
A message on the display will ask if
it is OK to format disk 1.
Type Y and do a Shift+CR/DEL.
Formatting the disk takes between
2
and
3
minutes.
You may
monitor the formatting process by watching the display
screen.
14. Type:
INIT 1
and do a Shift+CR/DEL.
A message on the display will ask if
it is OK to initialize disk drive 1.
Type Y and. do a
Shift+CR/DEL.
Then go to the next step.
(You may see the
message, Disk is Write Protected: Operation Aborted.
If you
have closed the write-protect slot of the destination disk,
as described in step 11, ignore this message.) .
15. Type:
COpy 2
1
and do a Shift+CR/DEL.
A message on the display wili ask if
it is OK to copy disk 2 to disk 1.
Type· Y and do a
Shift+CR/DEL.
You may monitor the copy progress by watching
the display screen.
16. Before removing the destination disk, you may verify a
successful copy by typing DIR and doing a Shift+CR/DEL.
Note the directory (list of files) displayed for the
destination disk.
Then remove the destination disk and
insert the source disk.
Again, type OIR and do a
Shift+CR/OEL.
The displayed directory of the source disk
should match the previously displayed directory of the
destination disk.
17. To make more copies of the same disk, repeat steps 11
through 16.
18. To make a copy of a different source disk, remove the disk
in the drive, type INIT 2 and do a Shift+CR/DEL.
A message
on the display will ask if it is OK to initialize.
Type Y
and do a Shift+CR/DEL.
When
os:
appears on the screen (the
os:
may overwrite an
os:
that is already on the screen),
insert the disk to be copied in the drive and do steps 8
through 16.
62950150
H-3
_._------------------------
. - - - - - - - - - - - ..
-
...
--.-
..
,
.....
,
_
...
_-,---_._
..
__
..
Need help?
Do you have a question about the CDC 790ICEM and is the answer not in the manual?