Initial Terminal Status/Communications Setup (Tekem - Control Data Corporation CDC 790ICEM Owner's Manual

c.
(---.
..
~
C)
c)
INITIAL TERMINAL STATUS/COMMUNICATIONS SETUP (TEKEM)
(Version 02A)
NOTE: Normally, you only do the steps described here if this is
the first time your workstation is communicating with a network
by using a modem. If the workstation has previously used a modem
to communicate with the network, ignore these steps.
1.
2.
3.
Turn on the workstation.
Check that the write-protect slot of the disk is closed. '
Insert the disk, metal edge first, label side up. The red
disk-active light will come on for a moment. When it goes
off, press the RESET SYSTEM swtich.
It will take the disk about 80 seconds to load. When the
READY FOR INPUT prompt appears on the screen of the text
display, press the key that is marked on top as
L
DELETE
C
and on the front as SETUP (this is the TEKEM SETUP key). An
asterisk
(*)
appears on the text display screen.
NOTE
Keys with their function
marked on the front, perform
that function only when the
TEKEM microcode is being used.
0:5473
4. Type STA and press NEXT
~nd
the Setup Screen appears. The
Setup Screen lists the way the terminal is set to operate.
F
62950150 F-l
- - - - - - - - - - - _ ..
-----_._--_
..
_.
__
. _ - - - - - - - - - - - -_
....
-
........
__
...
__
...
_._-_.
__
. - - - - - - - - - - - - - -