Table of Contents
Advertisement
COPYING FLEXIBLE DISKS
Flexible disks used with the 790 ICEM Workstation may be copied
by using this procedure.
1.
To do a disk copy, you must change the setting of the dip
switches on the display list processor board.
To change
these switches, use the Processor On switch to turn off the
workstation.
2.
Use a Phillips screwdriver to rotate the latches on the door
of the right-hand pedestal.
Open the door and set the
switches on the Display List Processor (DLP) board, slot A3,
as shown.
05488-1
3.
Find the TEKEM (510716-02) or TEKEM+ disk.
These disks
contain the ,copy program.
Make sure the write-protect slot
is open.
Then, insert the disk, metal edge first, label up,
into the disk drive and turn on the workstation with the
Processor On switch.
62950150
NOTE
In this procedure, when you see
Shift+CR/DEL, hold down a Shift
key and press the CR/DEL key.
(The CR/DEL key is to the right
of the space bar.)
Note that
the disk you copy from is
called the "source" disk and
the disk you copy to, is called
the "destination" disk.
H-l
H
_
....
"
....
-
...............
_--_.
__ ._--_._._----_
...
__
. _ - - - - - -
_._._----
---'"
..............
-
..
-
..
-.----
..
---
. _ - - - - - - _ . _ - _
.... _.
Advertisement
Table of Contents
Need help?
Do you have a question about the CDC 790ICEM and is the answer not in the manual?