c)
o
To change the baud rate, type BAUD, a space, and then· type
the rate, such as:
BAUD 4800
Then press the NEXT key.
If it is necessary to change any of the other parameters,
change them before going to the next step.
Following is a
list of the parameters that most often need to be changed.
If you change any of the these parameters, press the NEXT key
after typing each change.
ECHO - If the host is doing the echo, type ECHO N, otherwise
type ECHO Y.
PAR~TY
- This parameter should agree with the parity required
by
the~'
hos t computer.
Se le c t none, even, or odd,
by
typ i ng
PARITY N, PARITY E, or PARITY
0,
respectively.
FLAGGING - If the host computer supports XON/XOFF flagging,
type FLAG INPUT, otherwise, type FLAG NONE.
6.
Type STA and press NEXT and the parameters will again be
displayed on the screen.
If
you
have made any changes, they
s'hould appear on the parameter display.
CAUTION
Changing the SAVECONFIG parameter,
as described in the next step, is
normally only done when the
workstation is initially being
setup to'operate with a network.
7.
Type:
SAVEC Y and press NEXT.
8.
Press the L DEL C/SETUP key to save the changes on the disk.
CAUTION
To prevent possible damage to the
microcode disk, the SAVECONFIG
parameter must now be changed to NO
as described in the next step.
9.
After the disk has been updated with the changes, press the L
DEL/SETUP key and type SAVEC N and press NEXT.
Then, press
the L DEL C/SETUP key and the disk will again be updated.
62950150
F-3
.........
__
._
......
__
..
_-_
...
__
............
_ - - - - - - - - - - - _ .
..............
__
..
_._----_._-
- - - - - - - - - - - -
Need help?
Do you have a question about the CDC 790ICEM and is the answer not in the manual?