Control Data Corporation CDC 790ICEM Owner's Manual page 50

10. Remove the TEKEM disk and move the write-protect tab to the
open position. Then re-insert the disk in the disk drive.
11. If the TEKEM program does not work with the settings as they
now are, consult the information from the network, and the
application program manuals. If you want to permanently
change any more of the setup Screen settings, follow this
same procedure and remember to close the write-protect slot
before making the change and to open the write-protect slot
after making the change.
12. What you do after viewing or changing the SETUP SCREEN
depends upon the communication network, the host computer,
and the application program you will use. You may have to
log on to the system using the procedure defined by the ("
F-4
network. Consult the information from the network or the
'l,.',
manuals that came with your application program. Also, see
~
the Preparing to Use An Application Program, section
3,
of •
this manual.
If you still have a problem, call the Control Data
Applications Central Suport at:
1-800-227-9999
or
In Minnesota, 1-612-639-4040
or
CONTROLNET 239-4040
62950150