Error Messages - Control Data Corporation CDC 790ICEM Owner's Manual

('"
)
'-.,
Cj
ERROR MESSAGES
The following error messages may occur before the workstation is
connected to the host (remote) computer. The error messages you
may see, why the message appeared, and what you should do are
listed in the following table. -For error messages that may occur
after connecting to the host computer, see the applicable
application manuals.
ERROR MESSAGE
Error: drive not ready
Error: crc or lost data
Files not found
Ilegal jump: address X (etc.)
OSXX Boot Error
TAKE THIS ACTION
If this message appears while you
are loading a disk but the disk
still loads, everything is OK,
just ignore the message. This
message will also appear if you
do not have a disk properly
inserted in the disk drive.
Insert the disk, metal edge in
first, and label up.
You do not have a disk properly
inserted in the disk drive.
Insert the disk, metal edge in
first, and label up. Or the disk
may be damaged. Insert a disk or
try another disk.
You do not have a disk properly
inserted in the disk drive.
Insert the disk, metal edge in
first, and label up. Or the disk
may be damaged, or the file you
requested is not on the disk.
Enter the correct file name and
retry, or type OIR and press NEXT
to check the disk directory.
You do not have a disk in the
drive or there is a program
problem. Insert a disk or try
another copy of the disk.
A disk is not properly inserted
in the drive or the disk does not
contain the workstation operatiny
system. Try another disk.
o
62950150 0-1
----------_._---.....
.
.......
_ ...
_ ..
_._
..
-._
..
-------