Control Data Corporation CDC 790ICEM Owner's Manual page 54

4. After about 80 seconds, when the TEKEM disk has loaded,
Enter Date
appears on the display screen.
5. Do a Shift+CR/DEL and
\
Enter Time
appears on the screen.
6. Do a Shift+CR/DEL and
as:
appears on the screen.
7. If the disk to be copied is the TEKEM disk, leave it in the
drive. If the disk to be copied is not the TEKEM disk,
remove the TEKEM
disk~
check that the write-protect slot on
the disk to be copied (source disk) is open and insert the
disk into the drive, metal edge first, label up.
8. Type:
COpy 1 2
and do a Shift+CR/DEL.
9. When a message is displayed asking if it is OK to copy disk
1 to disk 2, type a Y and do a Shift+CR/DEL. The source
disk will then be copied into the workstations RAM. You may
monitor the progress of the copy by watching the display
screen.
10. When
os:
appears on the display (OS: may appear near the top
of the screen), remove the source disk from the drive.
11. Close the write-protect slot on the disk you will copy to
(destination disk).
12. Insert the destination disk in the drive.
H-2
62950150
l.
.t