Table of Contents
Advertisement
en
CHAPTER 10
Figure 10.6 Jumper settings
10.3.2 Wiring
Figure 10.7 Link cable
Installation Instructions
40
J1
J2
Closed = master
Open
= slave
After both link cards are installed the card of the master and slave DCU must be
connected to each other by use of the supplied link cable (figure 10.7).
Note
The length of the link cable is 1 metre. Do not extend the length
of this cable.
Master DCU
15-pole D connector
Male
Slave DCU
15-pole D connector
Female
DECT6000
Advertisement
Table of Contents
