Table of Contents
Advertisement
en
CHAPTER 8
Figure 8.3 Bottom view of the DCU
Figure 8.4 Installing an extension card into the DCU
Installation Instructions
26
2
1
1. Unscrew the 2 screws
2. Unscrew 4 screws
‚ at the bottom of the DCU (see figure 8.3).
3. Lift the top cover from the DCU.
4. Remove blind cover of the BS8-15 slot. Blind cover plates are slightly welded
to the DCU housing, tap out a blind cover plate with a screwdriver (see figure 8.3).
5. Insert the two plastic pins in the DCU main board.
6. Mount the extension card into the DCU main board (see figure 8.4).
7. Screw the extension card connector to the DCU housing (see figure 8.4).
8. Close the DCU.
2
at each side of the DCU.
DECT6000
2
BS 8-15
BS 0-7
2
1
Advertisement
Table of Contents
