Wiring; Software Configuration Of The Dcu - Bosch DECT6000 Installation Instructions Manual

4.3.5 Wiring

After the DCU is equipped with one or more ACUs and an extension card (optional)
it must be connected to the base stations, PABX and Alphadesk central control PC.
For information about how to connect them to the DCU refer to the documentation
of the relevant item.

4.3.6 Software configuration of the DCU

Note
After installing and wiring the DCU the software configuration has to take
place. This has to be done by use of the software installed on the
Alphadesk central control PC, described in the "Instructions For Use" of
the LBB 6511/00.
DECT6000
en
CHAPTER 4
Installation Instructions
9