en
CHAPTER 6
Figure 6.4 Bottom view of the DCU
Figure 6.5 Placing the ACU into the DCU
Installation Instructions
16
2
1
1. Unscrew the 2 screws
2. Unscrew 4 screws
‚ at the bottom of the DCU.
3. Lift the top cover from the DCU.
4. Remove blind cover of the first available slot. Blind cover plates are slightly
welded to the DCU housing, tap out a blind cover plate with a screwdriver
(see figure 6.4).
5. Place the ACU in the first available slot (ACU0...ACU7) (see figure 6.5).
6. Screw the ACU to the DCU housing with a Pozidrive size 1 screwdriver and
the two supplied screws.
7. Close the DCU.
2
at each side of the DCU (see figure 6.4).
DECT6000
2
BS 8-15
BS 0-7
2
1