Table of Contents
Advertisement
9.3 Installation
9.3.1 Mounting procedure
Repeaters are normally mounted on the wall, close to a wall socket (the length of the
power supply cable being approx. 3 m).
To mount a repeater, proceed as follows (see figure 9.4):
1. Mark the drill spots on the wall.
2. Drill two holes of 6 mm.
3. Mount the supplied plugs.
4. Pull the power supply cable through the orifice
Make sure to leave enough cable length to facilitate (dis)mounting of the repeater.
5. Mount the wall holder using the screws
The repeater
in position).
4
Figure 9.4 Mounting a repeater
can now simply be attached to the wall holder (push down and click
3
2
DECT6000
in the wall holder
provided.
50 mm
1
Installation Instructions
en
CHAPTER 9
.
31
Advertisement
Table of Contents
