Table of Contents
Advertisement
INSTALLATION
30
EATON Powerware
®
Energy Management System (EMS) Upgrade Kit User's Guide
11. Click the Feature Settings tab to display the EMS Feature Settings
page.
12. Configure the following Miscellaneous Features:
Feature Setting
Audible Horn Disabled
Meter Simulation Mode
Enabled
LCD Displays Input 1 V as L to L
LCD Displays Input 2 V as L to L
Enable THD Alarms
Enable Dual Input Mode
13. Configure the following Building Alarm Settings:
Feature Setting
Set Custom Alarm Name
Contact Type
Action When Active
NOTE To revert any changes made on the current page back to default settings before
Reload Config
saving, click
14. Click Save Config to save the settings to the EMS−UGK. Depending
on communication speed, updates take effect within 15–20
seconds.
Description
Select to disable the audible horn. If enabled, the horn
sounds for each new alarm and can be turned off by
pressing any key on the display.
Select to enable demonstration mode for use with a
simulator.
Select to display Line to Line voltages on the display.
If unselected, voltages display as Line to Neutral
voltages.
Select to enable Total Harmonic Distortion metering
alarms detected by monitor.
Select for dual input models.
NOTE Deselecting this option removes all selections
and displays for the second input.
Description
Type a name for Building Alarms 1 through 4.
Select if the Building Alarm is connected as
normally−closed.
Select the action to occur when the Building Alarm
becomes active.
.
S
164201724 Rev 1 www.powerware.com
Advertisement
Table of Contents
