Table of Contents
Advertisement
INSTALLATION
Front
Plate
Left Conduit
Box
Mounting
Slots
(4 places)
Ground Bonding Screw
12
EATON Powerware
®
Energy Management System (EMS) Upgrade Kit User's Guide
8.
If installing a right conduit box, connect the DB−9 extender cable
(installed on the extended serial port on the inside of the right
conduit box) to the serial port (Service) on the electronics module.
Figure 4 shows the location of the two serial ports.
9.
Slide the conduit box into place on one side of the electronics
module. Loosen the mounting bracket screws further if needed.
If installing conduit on both panels, repeat for the other conduit box.
Tighten the mounting bracket screws to secure the conduit box(es).
Mounting Bracket
Screws (8 places)
Figure 4. Conduit Box Option
10. Optional but recommended. Attach the conduit box(es) to the wall
with appropriate wall anchors (not supplied). Use one or more of
the four available mounting slots in each conduit box.
11. Verify that all hardware is mounted and aligned properly, then
tighten all screws. Verify the hardware is attached safely and
securely to the wall.
12. Continue to the following section, Electrical Connections."
Serial Port
Extended
(Service)
Serial Port
Front
Plate
Card Cover Plate
1.5" Bushing
1" Bushing
Right Conduit Box
S
164201724 Rev 1 www.powerware.com
2" Bushing
Advertisement
Table of Contents
