Register Handset Settings - Sharp UX-D1200SE Operation Manual

Register Handset Settings

Register Handset Settings
In order to be used, a cordless handset
must first be registered in the machine
(the base). The cordless handset that
came with the machine is already
registered. To register an additional
cordless handset, follow the steps
below.
♦
If the system PIN number has been
changed to a number other than
"0000" in the machine (see page 35),
or if you are registering the cordless
handset in more than one base, you
must use the personal registration
procedure on page 35 to register the
cordless handset.
♦
A cordless handset can be registered
in up to four bases. To register the
cordless handset in multiple bases,
repeat the personal registration
procedure on page 35 using each
base. To select which base the
cordless handset will normally be
used with, see page 37.
Registering a cordless handset
(regular procedure)
On the cordless handset
1
Press or until "SETTINGS"
appears and press OK.
2
Press or to select "ADVANCED
SET." and press
3
Press or to select "SET
HANDSET" and press
34
(Valid.).
(Valid.).
4
Select "REGISTRATION" and press
(Valid.).
5
Press (Yes). The handset enters
registration mode.
On the machine (the base)
MENU
1
Press , then
[REGISTER HS SETTING] appears
2
Press twice
3
Press .
•
The display will show [
] while the machine
ENTRY
communicates with the cordless
handset. When registration is
finished, [
HSX REGISTERED
appear, where "
the newly registered handset.
•
If registration fails, [
ENTRY ] will appear.
until
.
.
WAITING HS
] will
" is the number of
X
ABORT HS