Remove The Shipping Materials; Clean The Appliance; Lava Rock And Mystic Ember Placement; Glowing Ember Placement - Heatilator HEIR36H-IFT Installation Manual

B. Remove the Shipping Materials
Remove shipping materials from inside or underneath
the firebox.
• The splatter guard is a piece of corrugated material
used to protect the appliance during the installation
process before finishing work on the whole hearth is
complete. Splatter guards may be factory installed
or accompany the decorative front of the appliance,
depending on the fireplace model. Splatter guards
must be removed before appliance is fired.
WARNING! Risk of Fire! Close the ball valve before in-
stalling the splatter guard to prevent accidental lighting.
Remove the splatter guard before lighting the appliance.
C. Clean the Appliance
Clean/vacuum any sawdust that may have accumulated
inside the firebox or underneath in the control cavity.
D. Lava Rock and Mystic Ember Placement
1. Apply the lava rock and Mystic Embers as shown in
Figure 11.9. The lava rock and Mystic Embers are
to be placed around the base hearth refractory and
can be used to conceal the joints of the hearth base
refractory pieces.
Figure 11.9. Apply Mystic Embers
Heatilator • HEIR36-IFT, HEIR42-IFT, HEIR50-IFT Installation Manual • 2458-980 Rev. B • 8/17
E. Glowing Ember Placement
WARNING! Risk of Explosion! Follow ember placement
instructions in manual. DO NOT place embers directly over
burner ports. Replace ember material annually. Improperly
placed embers interfere with proper burner operation.
Ember material is shipped with this gas appliance. To place
the ember material:
• Embers CANNOT be placed directly over ports. Care
should be taken not to cover the lighting trail of ports
(from back to front).
• Place dime-size pieces of Glowing Embers® just in front
of the port trail, but not on or in between the ports (see
Figure 11.10). Care should be taken so that the ports are
not covered. Failure to follow this procedure will likely
cause lighting and sooting problems.
• Save the remaining ember materials for use during
appliance servicing. The embers provided should be
enough for 3 to 5 applications.
APPLY GLOWING EMBERS
ADJACENT TO PORTS
Figure 11.10. Location of Glowing Embers
53