Heatilator HEIR36H-IFT Installation Manual page 56

Log #5 (2284-705): Locate flat areas on Log #1 and Log #3 that will be used to position Log #5. See Figure 11. Place
Log #5 into appliance as shown in Figure 12. Log #5 should contact base refractory and rest on the flat areas as shown in
Figure 11. Burned portion of Log #5 should be in front of Log #1. Log should be about 1/2 inch from front outer edge of base
refractory when properly positioned. See Figure 12.
BURNED
PORTION
6
EDGE OF LOG USED
FOR POSITIONING
Figure 10.
Log #6 (2284-706): Locate flat areas on Log #2 and Log #3 that will be used to position Log #6. See Figure 11. Place Log
#6 into appliance as shown in Figure 13. Edge of Log #6, highlighted in Figure 10, will be about 1/2 inch from the center grate
tine on both HEIR36 and HEIR42. Right side of log contacts right grate tine.
4
1
2
3
Figure 12. Log #5 Placement
56 Heatilator • HEIR36-IFT, HEIR42-IFT, HEIR50-IFT Installation Manual • 2458-980 Rev. B • 8/17
5
BURNED
PORTION
5
1/2 INCH
FOR LOG #5
FOR
LOG #5
2
FOR LOG #6
Figure 11.
2
1/2 INCH
HEIR42 SHOWN
Figure 13. Log #6 Placement
4
2
Figure 14. Log Set Installed.
1
3
LOG DOES NOT
CONTACT GRATE
TINE
1
6
5
3