Heatilator HEIR36H-IFT Installation Manual page 58

Figure 6.
Log #3 (2285-703): Place log in appliance as shown in Figure 7. Log #3 should contact right and right center grate tines
and also be about 1/4 inch from right side refractory.
Log #4 (2285-704): See Figure 8. Place Log #4 in appliance with burned edge facing center. The bottom of log #4 will rest
against left side refractory and on bottom refractory. Slide bottom of Log #4 toward front of appliance until it contacts back
side of Log #2. Rest top of Log #4 in notch on top left corner of Log #1. See Figure 2 and Figure 9.
Figure 8.
Log #5 (2285-705): Locate notched area on Log #1 that will be used to position Log #5. See Figure 2. Place Log #5 into
appliance with "burned" edge toward center of appliance. See Figure 11. Log will sit on bottom refractory and should be
about 1-1/2 inches from right grate tine. The center of the log should rest in notch on Log #3 and the top of Log #5 should
rest in the notch on Log #1.
BURNED EDGE
6
Figure 10.
58 Heatilator • HEIR36-IFT, HEIR42-IFT, HEIR50-IFT Installation Manual • 2458-980 Rev. B • 8/17
3
4
BURNED EDGE
5
1
LOG CONTACTS
GRATE TINES
Figure 7.
LOG CONTACTS SIDE
REFRACTORY
Figure 9.
NOTCH FOR LOG #6
1-1/2 IN.
(APPROXIMATELY)
Figure 11.
1/4 IN. FROM LOG
TO REFRACTORY
3
NOTCH FOR LOG #5
4 1
2
5
LOG CONTACTS
REFRACTORY