Power Adapter Line Connection; Power Adapter Phone Connection; Installing The Wall Power Adapter (Optional Component); Installing The Keycaps (Sp-300, Sp-400) - Telematrix SP-100 User Manual

POWER ADAPTER LINE CONNECTION

(SP-300, SP-400)
The power adapter LINE connection is used to
connect the telephone line from the wall jack
to the power adapter . Using one of the 12-foot
modular telephone line cords, connect one end of
the cord to the RJ14 telephone jack on the wall or
base board . The remaining end of the cord plugs
into the IN side of the power adapter .

POWER ADAPTER PHONE CONNECTION

(SP-300, SP-400)
The power adapter PHONE connection is used to
provide both the telephone lines and the power
source to the telephone . Using one of the 12-foot
modular telephone line cords, plug one end of the
line cord into the back of the telephone . Plug the
remaining end to the power adapter jack labeled
OUT .
Troubleshooting Note: If there is no power to the
telephone after connecting the line cords, check
to see if the line cords are inserted on the opposite
sides of the adapter .
INSTALLING THE WALL POWER ADAPTER
(OPTIONAL COMPONENT) (SP-300, SP-400)
This component is best used when wall mounting
the telephone . To install, simply plug the power
adapter into a standard 120V AC power outlet . A
mounting hole is provided to secure the power
pack to the AC wall outlet . Plug the AC power
pack directly into the wall outlet and then plug
the coaxial connector into the receptacle marked
POWER located on the back of the telephone .
Power Outlet Configuration The SpectrumPlus
telephone requires external power from a standard
120V outlet (60Hz) . It is rated 9VAC, 300mA .
IMPORTANT! The telephone will not function if
the line cord connections are not correct . Be sure
SPECTRUM SERIES USER GUIDE www.telematrix.net
that the telephone line cord connections are not
reversed (LINE/PHONE) . Attach the line cords to
the power adapter and the wall before connecting
to the telephone . SpectrumPlus line cords are
6-Pin 6-Conductor line cords (6P6C line cord) .
Replacement line cords must be same .

INSTALLING THE KEYCAPS (SP-300, SP-400)

Twenty-two preprinted named feature keycaps are
provided to identify the speed dial keys .
There are eleven clear keycaps already installed .
To install preprinted keys, remove the clear keycap
by simply pulling up . Replace with the preprinted
keycaps or place hand written paper index sheets
under a clear keycap . Program each speed dial
key for the specific function of the key .
Note: For speed dial programming instructions,
see the section on Programming Procedure For
SpectrumPlus Speed Dial Features in this manual .
There are four additional clear keycaps and two
index sheets provided as spares . Use these for
your own personal speed dial identities . Write the
speed dial name on the blank speed dial index
cards and insert into the blank keycaps . Place the
keycap on the correct memory speed dial location
(see index sheets provided in box) .
The twenty-two preprinted keycap names are
below:
Call Fwd On
Call Fwd Off
Transfer
Conf
DND
Call Back
Cancel Call Back
Call Park
Call Pick-up
Group Call Pick-up
Paging
Ring Again
Save Msg
Del Msg
Rpt Msg
Skip Msg
FF Msg
Rew Msg
Emergency
Help Desk
Information
911
7