Installation; Caution Information; Connecting The Handset Cord; Connecting The Line Cord - Telematrix SP-100 User Manual

• Programmable Flash Key
• Programmable Pause Key
• Desk or Wall Mountable
• Fully Modular, Easy To Install
* Visual Message Waiting are features that require
subscription to your local telephone company or
PBX provided service . These telephone features
will not work unless you are a subscriber .

Installation

CAUTION INFORMATION

• Never install telephone or network wiring
during a lightning storm .
• Never install telephone or Ethernet jacks in
wet locations unless the jack is specifically
designed for wet locations .
• Never touch uninstalled telephone wires or
terminals unless the telephone line has been
disconnected at the network interface .
• Use caution when installing or modifying
telephone and network lines .

CONNECTING THE HANDSET CORD

A 10-foot modular coil handset cord is provided .
(Be sure that the wall/desk elevation stand has not
been attached.) To install the cord, simply plug the
short end of the handset cord into the modular jack
on the handset . The long end of the handset cord
plugs into the jack labeled Handset located on the
bottom of the SpectrumPlus base unit . Place the
line cord into the handset coil cord channel located
directly below the jack .

CONNECTING THE LINE CORD

This is a line-powered telephone . Connect the
RJ-14 line cord into the wall jack and then into
the bottom of the phone for power . When inserted
properly, dial tone will be available .
SPECTRUM SERIES USER GUIDE www.telematrix.net

WALL MOUNTING

The SpectrumPlus is designed to be conveniently
wall mounted without
hardware . Follow these easy steps:
1 . The handset retaining clip must be in the
correct position to secure the handset
into the handset cradle . Engage the clip
with your fingers and pull the clip forward
(towards you), rotate the clip 180º and snap
the clip back into place . The retaining clip
cannot be removed .
2 . The SpectrumPlus has provisions for a
mounting wedge that must be correctly
positioned . This wedge allows the telephone
to be viewed at a correct angle when the
phone is wall mounted . Remove the wedge
from the phone base .
3 . Secure the line cord, coil cord and any
wiring in place prior to installing the wall
mount wedge . The wall mount base has
extra large wiring channels and strain relief
poles for containing the wires in a neat and
orderly way . Wrap the wires around the
strain relief poles and then secure the wires
through the channel .
4 . To wall mount, place the narrow edge at the
top edge of the phone base and slide the
wedge upward into place .
5 . Lock the wall mount into position by sliding
the locking button to the right .
Note: A 6-inch line cord is provided for when the
telephone is to be wall mounted . Connect one
end of the line cord to the phone jack and the
other end to the wall jack . Be sure to connect and
line cord before placing mounting wedge on the
bottom base .

DESK MOUNTING

To install the wedge for desk mounting, be sure
the lock mechanism is positioned to the left clear
requiring additional
5