Message Waiting Light Indicator; Switch Settings; Message Waiting Selector; 120V Ac Outlet Recovery Power Adapter (Provided) - Telematrix SP-100 User Manual

of the locking arm . Place the wedge in the slots,
wide end toward top of phone base unit, and slide
the wedge upward into position . Lock the wedge
into place .

MESSAGE WAITING LIGHT INDICATOR

The SpectrumPlus telephone has a Message
Waiting (MW) Light Indicator . The indicator will
blink to indicate that a new message is in the
user's voice mailbox . The SpectrumPlus supports
the following telephone or PBX supplied message
waiting signals:
SP-100:
1 . 90-Volt NEON message waiting light
indicator signal provided by a PBX .
2 . Low Voltage LED message waiting light
indicator light signal is provided by a PBX .
The PBX system or telephone service provider has
to activate the voice mail feature for the light to
illuminate and work properly . Be sure that your
telephone service provider or PBX system has the
compatible messaging service available in your
area or facility .
SP-300 and SP-400:
1 . Telephone Company VMWI Service* (FSK
signal compatible, subscription to local
telephone company is required) .
2 . Or, Audible Stutter Dial Tone (SDT) signals
provided by local telephone company .
3 . Or, 90-Volt NEON message waiting light
indicator signal provided by a PBX .
4 . Low Voltage LED message waiting light
indicator light signal is provided by a PBX .
The PBX system or telephone service provider has
to activate the voice mail feature for the light to
illuminate and work properly . Be sure that your
telephone service provider or PBX system has the
compatible messaging service available in your
area or facility .
6
Note: The SpectrumPlus telephone automatically
reads the Message Waiting (MW) signals supplied
by your service provider . The LED signal supplied
by a PBX must have the LED Voltage switch which
is located on the back of the telephone in the
correct position to operate the LED .
Feature Note: Message ON/OFF Notification .
Use this feature when alerting another that a saved
message is in voice mail for that person or use this
feature when you simply want to turn the light off .
Be Aware: If there is a new incoming message and
the telephone company continues to send a new
signal this light will re-activate . This will occur
only when there is a new voice mail that has not
been heard .
How To Use: When on-hook, press the "*" key
for 3 to 5 seconds and the message LED will
automatically turn on . At any time press "*" key
for 3 to 5 seconds, message LED will turn off .
*Definition: VMWI is Visual Message Waiting
Indication . This option requires a subscription to
your local telephone service provider for TouchLite
to activate .
120V AC OUTLET RECOVERY POWER
ADAPTER (PROVIDED) (SP-300, SP-400)
The 120 VOLT AC Outlet Recovery Power Adapter is
a featured TeleMatrix product . It provides both the
telephone lines and the power source in one cable
(6P6C line cord) and is designed to recover the use
of the power outlet .
CONNECTOR CONFIGURATION (SP-300,
SP-400)
The 120 Volt Outlet Recovery Power Adapter has
two modular jacks . One jack is labeled LINE and
the other jack is labeled PHONE . These jacks allow
for a fully modular installation .
www.telematrix.net SPECTRUM SERIES USER GUIDE