Graco D200 Repair Manual page 19

Reassemble 20, 30, and 60 Liter Wiper
Assemblies
1. Assemble wiper assembly.
a. For single wiper assemblies: Place bottom plate
(455) on flat surface. Place wiper support (454),
wiper (453), spacer (452), and top plate (457)
on bottom plate (455).
b. For single wiper assemblies with SST platens:
Place bottom plate (455) on flat surface. Place
wiper support (454), wiper (453), flowered wiper
support (460), PTFE spacer (452), and top plate
(457) on bottom plate (455).
Single Wiper Platen
456
459
457
452
453
454
455
F . 14: Single and Double Wiper Assemblies
IG
313527ZAD
Single Wiper with
470
469
461
459
462
456
465
451
457
452
460
453
454
455
c. For double wiper assemblies: Place bottom
plate (455) on flat surface. Place wiper support
(454), wiper (453), spacer (452), wiper (453)
and top plate (457) on bottom plate (455).
d. Install eight nuts (409) on outer ring. Torque to
45 in-lbs (61 N•m).
e. Replace o-ring (456), or install new o-ring under
platen casting (451). Use lubricant to hold in
place.
f. Install platen casting (451). Tighten with four
nuts (509).
SST Platen
470
469
459
462
465
451
459
Maintenance Procedures
Double Wiper Platen
461 459
451
456
459
457
453
452
453
454
455
462
465
19