Casablanca Isotope Installation Instructions Manual page 15

Wall Control For Dual Switches
To install the Casablanca Wall Control into a dual switch location,
you will need a wall plate with both a standard switch and rocker
switch cut-out (sold separately).
If you are unfamiliar or
uncomfortable with wiring, please
contact a qualified electrician.
1
Installing the battery
To access the battery compartment,
slide the battery door up.
Replace the used battery with two AAA
batteries when needed.
(Sold Separately)
Battery
Door
15
M8546-01 • 03/23/17 • © 2017 Casablanca Fan Company
www.CasablancaFanCo.com
2
Verify which switch controls the fan light.
1. Turn on power for the fan.
2. Push both existing wall switches to
the on position.
3. Press the Fan and Light button on
the Casablanca Wall Control.
4. Your fan's light and fan should be
on.
5. Push each of your existing wall
switches into the off position one at
a time to determine which switch
controls the Light.
6. The Light switch will not be
replaced when installing the
Casablanca Wall Control. You may
find it helpful to mark the Light
switch with a pencil or some other
non-permanent mark.
IMPORTANT
3
Turn off the power
Ensure the power is OFF at the outlet
box and wall switch location before
proceeding with installation.
1.888.227.2178
ON
OFF