Beam IsatDock LITE User Manual page 25

Hide thumbs Also See for IsatDock LITE:
Table of Contents

Advertisement

BETA – IsatDock Drive/Lite Overview
10.1. FCC Information
This equipment has been tested and found to comply with the limits for a Class B
digital devices, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one of
more of the following measures: 
Reorient or relocate the receiving antenna
Increase the separation between the equipment and receiver
Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Warning: Changes or modifications not expressly approved by <manufacturer> could void the
user's authority to operate the equipment
"This device has been designed to operate with the antennas listed below, and having a
maximum gain of 6 dBi dB. Antennas having a gain greater than 6 dBi dB are strictly
prohibited for use with this device."
 
"To reduce potential radio interference to other users, the antenna type and its gain should
be so chosen that the equivalent isotropically radiated power (EIRP) is not more than that
required for successful communication"
All antenna cable used with these antenna must have a dB loss of 6.5dB or greater.
WARNING: To satisfy FCC RF exposure requirements for mobile
The antenna used for this transmitter must not be co-located in conjunction with any
other antenna or transmitter
Page 25 of 25
transmitting devices, a separation distance of
should be maintained between the antenna of this device and
persons during device operation. To ensure compliance,
operations at closer than this distance is not recommended.
Beam Communications
STRICTLY CONFIDENTIAL
55 cm
or more

Advertisement

Table of Contents
loading

This manual is also suitable for:

Isatdock marineIsatdock proIsatdock drive

Table of Contents