Start All Four Screws, And Then Tighten Them - ICON PETL59817.0 User Manual

14. Remove the 5/16" Nut (20) and the 5/16" x 2 1/4"
Bolt (79) from the bracket on the Latch Crossbar
(67).
Align the upper end of the Storage Latch (68)
with the bracket on the Latch Crossbar (67), and
insert the 5/16" x 2 1/4" Bolt (79) through the
bracket and the Storage Latch. This will push a
spacer (Q) out of the Storage Latch; discard
the spacer.
Next, tighten the 5/16" Nut (20) onto the 5/16" x
2 1/4" Bolt (79). Do not overtighten the Nut;
the Storage Latch (68) must be able to pivot.
Then, lower the Frame (38) (see HOW TO
LOWER THE TREADMILL FOR USE on
page 22).
15. Attach the Tablet Holder (92) with four #8 x 3/8"
Screws (91); start all four Screws, and then
tighten them. Do not overtighten the Screws.
16. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of plastic
on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the treadmill. To
avoid damage to the console, keep the treadmill out of direct sunlight. Keep the included hex keys in a secure
place; one of the hex keys is used to adjust the walking belt (see pages 24 and 25). Note: Extra hardware
may be included.
14
20
38
15
92
91
13
Q
67
79
68
91