ICON PETL59817.0 User Manual page 11

10. With the help of a second person, hold the con-
sole assembly (K) near the Right Handrail (64).
See the inset drawing. Connect the Upright
Wire (63) to the console wire (L). The connec-
tors should slide together easily and snap
into place. If they do not, turn one connector
and try again. IF YOU DO NOT CONNECT THE
CONNECTORS PROPERLY, THE CONSOLE
MAY BECOME DAMAGED WHEN YOU TURN
ON THE POWER. Then, remove the wire tie (D)
from the Upright Wire.
Connect the two Console Ground Wires (88)
to the two ground wires (M) on the Console
Crossbar (61).
11. Insert the Wires (63) into the Right Handrail (64)
through the indicated hole (N) as you set the
console assembly on the Left and Right Uprights
(66, 76). Make sure that no wires (63, 88) are
pinched.
Attach the console assembly (K) with ten #8 x
3/4" Screws (4); start all ten Screws, and then
tighten them. Do not overtighten the Screws.
See step 5. Firmly tighten the six 3/8" x 3 1/4"
Screws (2).
10
K
L
63
64
11
63
N
4
64
4
76
11
61
D
L
63
K
88
4
4
66
M
88
4