Installation Space For Outdoor Unit; Layout; Top View Of The Outdoor Unit - Carrier Xpower Series Installation Manual

4.6 Installation space for outdoor unit

Ensure enough space for maintenance. The modules in the
same system must be on the same height.(Fig.4-7)
When installing the unit, leave space for maintenance, as
shown in Fig.4-8. Install the power supply at the side of the
outdoor unit. For the installation procedure, see the Installation
manual for the power supply device.
If there are obstacles above the outdoor unit, refer to Fig.4-13.
(Air-in )
Installation and maintenance surface
100mm~500mm
>1000mm

Top view of the outdoor unit

4.7 Layout

When the outdoor unit is higher than the surrounding obstacle
One row
>1m
Front
100-500mm
Tow rows
>1m
Front
Front
100-500mm
(Air-out )
Fig.4-7
>1000mm
100mm~500mm
>1000mm
>1000mm
Fig.4-8
Front
Front
Front
More than two rows
>1m
Front
Front
Front
When the outdoor unit is lower than the surrounding obstacle,
(Air-in )
refer to the layout used when the outdoor unit is higher than
the surrounding obstacle. However, to stop cross connection
from the outdoor hot air affecting heat exchange, add an air
director to the exhaust hood of the outdoor unit. See the figure
below. The height of the air director is HD (H-h). Make the air
director on site.
>1m
If miscellaneous items are placed around the outdoor unit, they
must be 800 mm below the top of the outdoor unit or a manual
exhaust device must be added.
Fig.4-9
Fig.4-10
Front
Front
Front
100-500mm
Front Front
100-500mm
A
C
B
Front view Side view
A
B
Front view
Front view
>45° B >300mm
A
C
>1000mm D Airflow deflector
Fig.4-11
Fig.4-12
D
A
B
Fig.4-13
Installation manual
7