Operation-Dash Mounted - Kustom Signals Falcon HR Operator's Manual

7.3 OPERATION—DASH MOUNTED
7.3.1 SETUP
For dash-mounted moving / stationary operation, the
FalconHR can use the corded or cordless handle or the
optional mounting pod.
Units with the optional mounting pod can use either the
wireless or the wired remote. The following steps
describe connecting the mounting pod.
1. Turn unit off; unplug power cord. Remove the handle
from the FalconHR by pressing the handle release
button (latch) on the bottom of the indicator.
2. Slide the indicator onto the mounting pod, pushing
rearward until the release button clicks, indicating the
unit is securely in place.
3. Connect the remote control and speedometer input
cables as required. Plug the unit in, turn on.
Dash mounted units with a handle use the wireless IR
remote and must use the KSI provided handle dash mount.
This specialized mount allows the unit to detect if it is
handheld or dash-mounted. While dash-mounted, the
trigger is inoperable, the IR remote is active, and moving
modes are allowed. While handheld, moving modes are
not allowed, the remote is inoperable and the trigger must
be pulled to activate the transmitter.
1. Set the range and audio levels as needed; select
operating mode.
2. Aim antenna directly at vehicles being monitored.
7.7