Chapter 2 Hardware Installation; Memory Module (So-Dimm) I Nstallation - Winmate IB32 User Manual

3.5” sbc with intel bay trail processors, hdmi, lvds, vga, dual giga ethernet, and mini-pcie interface
Hide thumbs Also See for IB32:
Table of Contents

Advertisement

User Manual

Chapter 2 Hardware Installation

2.1 Memory Module (SO-DIMM) Installation
The IB32 Motherboard has two 204-pin SODIMM slot. The socket supports up to 8GB
DDR3L 1333/1600 SDRAM. When installing the –memory unit, please follow the steps
below:
Steps 1 Firmly insert the SO-DIMM at an angle of about 30-degree into the slot. Align
the SO-DIMM with the slot until it is fully inserted. The notch on the SO-DIMM
should match the break on the slot.
Step 2 Press downwards on SO-DIMM until the retaining clips at both ends fully snap
closed and the SO-DIMM is properly seated.
CAUTION
The SO-DIMM only fits in one correct orientation. It will cause
permanent damage to the development board and the SO-DIMM if the
SO-DIMM is forced into the slot at the incorrect orientation.
Chapter 2
8
Hardware Installation

Advertisement

Table of Contents
loading

Table of Contents