Electrical Parameters; View Analyzer Limit - Fluke 438-II User Manual

Electrical Parameters

The second screen is the electrical power and power factor. It shows the voltage unbalance and harmonics
voltage factor according to NEMA MG1.
Use 
Softkeys:






View Analyzer Limit

The View Analyzer Limit screen has the same information as the Set Analyzer Limits screen but is read-
only. The only allowed action is  (OK or BACK) to go to the Motor Analyzer screen where the LIMITS
screen was activated.
To change the information:
1. Go to the MOTOR ANALYZER screen or METER screen.
2. Press  to stop the process.
to move between the screens for electrical and mechanical parameters.
View ANALYZER LIMITS screen.
Select METER screen.
Select DERATING screen.
View MOTOR SETUP screen.
STOP measurements and save measurement results.
Motor Analyzer
Motor Analyzer Parameters
9