Table of Contents
Advertisement
Record by Manual Trigger
If POWER/LINK
Data mode, any recorded Live Data will be erased from the
Scan Tool's memory.
Record by DTC Trigger
This function automatically records Live Data information when a DTC
sets and saves it in the Scan Tool's memory. The recorded data can be
a valuable troubleshooting aid, particularly if you are experiencing a fault
that is causing a DTC to set. The Scan Tool can record approximately
100 frames of Live Data.
1. With the Scan Tool in Live Data mode (see VIEWING LIVE DATA
on page 22), press and hold LD to access the Live Data Menu, then
release.
2. Select Record Live Data, then press ENTER
The Record Live Data Menu displays.
If the Scan Tool fails to establish communication with the vehicle,
a "Communication Error" displays.
- Ensure your vehicle is OBD2 compliant.
- Verify the connection at the DLC, and verify the ignition is ON.
- Turn the ignition OFF, wait 5 seconds, then back ON to reset
the computer.
- Press POWER/LINK
3. Select Record by DTC Trigger, then press ENTER
The Select PIDs to Record screen
displays.
4. Press UP
through the available PIDs. When a PID
you wish to record is highlighted, press
ENTER
confirm your selection). Repeat until
only the PIDs you want to record have
all been selected.
To deselect a PID, highlight the PID, then press ENTER
The checkmark is removed.
To record all PIDs, select Record All PIDs, then press LD to
continue.
5. When you are finished making your selections, press LD to continue.
If DTCs are presently stored in the vehicle's computer, an
advisory message displays.
RECORDING (CAPTURING) LIVE DATA
is pressed at any time while in Live
and DOWN
(a "checkmark" shows to
Live Data Mode
.
to continue.
to scroll
.
.
25
Hide quick links:
Advertisement
Table of Contents
