Viewing Abs Dtcs - Matco Tools MD95 Operating Instructions Manual

If no codes are present, a "System
Pass" message is displayed. Press
SYSTEM MENU
System Menu.
6. If more than one code was retrieved
press DTC/FF, as necessary, to display
additional codes one at a time.
Whenever the Scroll function is used to view additional codes,
the Scan Tool's communication link with the vehicle's computer
disconnects. To re-establish communication, press POWER/
LINK
7. When the last retrieved DTC has been displayed and DTC/FF is
pressed, the Scan Tool returns to the "Priority" Code.
To view additional enhanced DTCs, repeat steps 1 through 5,
above.
To exit the enhanced mode, press SYSTEM MENU
to the System Menu. Select Global OBD, then press ENTER
to return to the Global OBD2 mode.

VIEWING ABS DTCs

Refer to the manufacturer's website for vehicle makes covered.
Reading ABS DTCs
1. When ABS is chosen from the System Menu, a "One moment
please" message displays while the Scan Tool retrieves the selected
DTCs.
If ABS functionality is not supported by the vehicle under test, an
advisory message shows. Press SYSTEM MENU
the System Menu.
If the Scan Tool fails to link to the vehicle's computer, a
"Communication Error" message shows.
- Ensure your vehicle is OBD2 compliant.
- Verify the connection at the DLC, and verify the ignition is ON.
- Turn the ignition OFF, wait 5 seconds, then back ON to reset
the computer.
- Press POWER/LINK
In the case of long code definitions, a small arrow is
shown in the upper/ lower right-hand corner of the
code display area to indicate the presence of
additional information.
to return to the
again.
Using the Scan Tool
VIEWING ABS DTCs
to continue.
to return
to return to
15