Network Test - Matco Tools MD95 Operating Instructions Manual

If the Scan Tool fails to link to the vehicle's computer, a
"Communication Error" message shows.
- Ensure your vehicle is OBD2 compliant.
- Verify the connection at the DLC, and verify the ignition is ON.
- Turn the ignition OFF, wait 5 seconds, then back ON to reset
the computer.
- Press POWER/LINK
If the Scan Tool cannot link to the vehicle's computer after three
attempts, the message "Contact Technical Support" displays.
- Press SYSTEM MENU
- Turn the ignition off, and disconnect the Scan Tool.
- Contact Technical Support for assistance.
2. Refer to DISPLAY FUNCTIONS on
page 4 for a description of LCD display
elements.
If the definition for the currently
displayed code is not available, an
advisory message shows.
I/M MONITOR STATUS icons are
not displayed when viewing SRS
DTCs.
In the case of long code definitions, a small arrow is shown in
the upper/lower right-hand corner of the code display area to
indicate the presence of additional information.
If no codes are present, a "No SRS DTC's are presently stored
in the vehicle's computer" shows. Press SYSTEM MENU
return to the System Menu.
3. If more than one code was retrieved press DTC/FF, as necessary,
to display additional codes one at a time.
Whenever the Scroll function is used to view additional codes,
the Scan Tool's communication link with the vehicle's computer
disconnects.
POWER/LINK
4. When the last retrieved DTC has been displayed and DTC/FF is
pressed, the Scan Tool returns to the "Priority" Code.
To exit the enhanced mode, press SYSTEM MENU
to the System Menu. Select Global OBD, then press ENTER
to return to the Global OBD2 mode.

NETWORK TEST

The Network Test lets you perform a scan of all vehicle modules, or of a
single selected module, to retrieve DTCs associated with the module(s).
Using the Scan Tool
to continue.
to return to the System Menu.
To re-establish
again.
NETWORK TEST
communication,
to return
to
press
17