Master/Slave Mode - Ledj Rapid QB1 User Manual

Master/slave mode:

To set the master unit, press the "MENU" button and use the "UP" and "DOWN" buttons on the front
N-5
of the unit to show
"DOWN" buttons to choose
desired program.
To set the other units in slave mode, press the "MENU" button and use the "UP" and "DOWN" buttons
on the front of the unit to show
"UP" and "DOWN" buttons to choose
will now run in sequence with the master unit.
To exit out of any of the above options, press the "MENU" button.
Please ensure that all slave units are set to the same DMX channel mode as the master unit.
Software version:
To display the software version, press the "MENU" button and use the "UP" and "DOWN" buttons on
the front of the unit to show
version will be displayed. To exit out of any of the above options, press the "MENU" button.
Fixture hours:
To display the fixture hours, press the "MENU" button and use the "UP" and "DOWN" buttons on
the front of the unit to show
will be displayed. To exit out of any of the above options, press the "MENU" button.
Remaining battery life:
To display the batteries charge, press the "MENU" button and use the "UP" and "DOWN" buttons on
the front of the unit to show
charge will be displayed between
To exit out of any of the above options, press the "MENU" button.
Battery reference information:
When the battery charge indicator LED is illuminated red, the fixture is recharging.
When the battery charge indicator LED is illuminated yellow, the fixture is has less than 30% charge.
When the battery charge indicator LED is illuminated green, the battery is charged.
The recharging time for the battery is 5 hours when the unit is powered off and 9 hours when the unit
is powered on.
The battery usage time from fully charged is dependant on the mode and brightness of the fixture.
For more information please see the features on page 3.
www.prolight.co.uk
on the LED display. Now press the "ENTER" button and use the "UP" and
Nast
. Press the "ENTER" button to confirm the setting. Then select your
N-5
on the LED display. Now press the "ENTER" button and use the
SLAV
. Press the "ENTER" button to confirm the setting. The unit
uEr
on the LED display. Press the "ENTER" button and the software
HoUr
on the LED display. Press the "ENTER" button and the fixture hours
batt
on the LED display. Press the "ENTER" button and the battery
000 100
~ (0-100%).
Operating instructions
Rapid QB1 User Manual
10