Table of Contents
Advertisement
Alcatel-Lucent Enterprise
AIC Expansion board: Location
Fig. 16:
(6) Using a screwdriver, remove the cover covering the expansion slot. This cover is located on the rear panel.
Push this out.
Removing the SLOT 2 cover
Fig. 17:
(7) Place the AIC board standoff posts over the securing screws. Secure these firmly.
(8) Place the AIC card in the slot so that this firstly adjusts to the space on the device rear panel and subsequently
to the two AIC connections. This operation must be carried out carefully, without forcing any piece or part of the
device. Check that the board is clearly settled over the AIC connectors. Please see
Inserting the AIC expansion card
Fig. 18:
(9) Screw the AIC board to the standoff posts using two screws and their corresponding washers. Firmly tighten the
screws without damaging the board.
Screwing down the AIC expansion card
Fig. 19:
(10) Reposition the expansion slot cover and screw it down
Repositioning the SLOT 2 cover
Fig. 20:
(11) Rearrange the top panel flap and screw it into place using the screws. Please see
(12) Connect and switch on the device, as described in section
lems, switch off the device and make sure that the above steps have been carried out correctly. If the problem
OA58XX Router
Fig. 18
Fig. 14
Connecting
on page 19. Should you detect any prob-
3 Components and Power Supply
on page 13.
on page 11.
13
Hide quick links:
Advertisement
Table of Contents
