GE F60 Instruction Manual page 119

4 HUMAN INTERFACES
3. Enter the template password then click OK to apply the template.
Once the template has been applied, users will only be able to view and edit the settings specified by the template. The
effect of applying the template to the phase time overcurrent settings is shown below.
Phase time overcurrent settings window without template applied.
Figure 4–4: APPLYING TEMPLATES VIA THE VIEW IN TEMPLATE MODE COMMAND
Viewing the settings in template mode also modifies the settings tree, showing only the settings categories that contain
editable settings. The effect of applying the template to a typical settings tree view is shown below.
Typical settings tree view without template applied.
Figure 4–5: APPLYING TEMPLATES VIA THE VIEW IN TEMPLATE MODE SETTINGS COMMAND
Use the following procedure to display settings available for editing and settings locked by the template.
1. Select an installed device or a settings file from the tree menu on the left of the EnerVista UR Setup main screen.
2. Apply the template by selecting the Template Mode > View All Settings option.
3. Enter the template password then click OK to apply the template.
GE Multilin
4.1 ENERVISTA UR SETUP SOFTWARE INTERFACE
Phase time overcurrent window with template applied via
Template Mode > View In Template Mode
the
The template specifies that only the
settings be available.
Typical settings tree view with template applied via
Template Mode > View In Template Mode
the
command.
F60 Feeder Protection System
command.
Pickup and Curve
842858A1.CDR
842860A1.CDR
4-7
4