Configuring Sdh Path Parameters - Cisco ASR 900 Series Configuration Manual

Configuring SDH Path Parameters

BER thresholds: SF = 10e-5 SD = 10e-5TCA thresholds: B1 = 10e-6 B2 = 10e-5--More--*Apr 20
04:19:29.006 PDT: %CLEAR-5-COUNTERS: Clear counter on all interfaces Rx: S1S0 = 00K1 = 00,
K2 = 00J0 = 00RX S1 = 00Tx: S1S0 = 00K1 = 00, K2 = 00J0 = 00Tx J0 Length : 16Tx J0 Trace
:74 78 4D 65 73 73 61 67 65 20 20 20 20 20 20 00
txMessage .Expected J0 Length : 16Expected J0 Trace :72 78 4D 65 73 73 61 67 65 20 20 20
20 20 20 00
rxMessage .Rx J0 Length : 16Rx J0 Trace :CRC-7: 0xE7 ERROR01 01 01 01 01 01 01 01 01 01 01
01 01 01 01 00 ................SDH Line
Tables
INTERVAL CV ES SES UAS04:19-04:19 0 0 0 0
Configuring SDH Path Parameters
This section describes the configuration of SDH path parameters.
Path Overhead
J1 Flag
Sets the message length and the message text of the High Order Path Trace identifier (J1).
C2 Flag
Sets the C2 byte in the Path OverHead (POH) to indicate the contents of the payload inside the frame.
The path overheads, C2 flag and J1 flag can be configured for the following modes:
• AU-4 Mapping
• AU-3 Mapping
Configuring C2 Flag
To configure the C2 flag:
enable
configure terminal
controller Mediatype 0/0/16
mode sdh
controller sdh 0/0/16
au-4 1
overhead c2 10
end
1 port OC48/ 4 port OC12/OC3 + 12 port T1/E1 + 4 port T3/E3 CEM Interface Module Configuration Guide, Cisco
IOS XE Fuji 16.7.x (Cisco ASR 900 Series)
118
◦ Mode VC-4
◦ Mode VC-4 Nc
◦ Mode TUG-3
For more information, refer
◦ Mode E3
◦ Mode T3
For more information, refer Configuring Modes under AU-3 Mapping.
Configuring Modes under AU-4 Mapping, on page
Configuring SDH
104.