Configuring Satop - Channelized T3/T1 Interfaces; Verifying The Cem Configuration Of Channelized T3/T1 Interfaces; 1 Port Oc48/ 4 Port Oc12/Oc3 + 12 Port T1/E1 + 4 Port T3/E3 Cem Interface Module Configuration Guide, Cisco - Cisco ASR 900 Series Configuration Manual

Configuring T3 Interfaces

Configuring SAToP - Channelized T3/T1 Interfaces

Configuring SAToP - Channelized T3/T1 Interfaces
Before SAToP is configured, the controller of channelized T3/T1 interface must be configured.
enable
configure terminal
controller t3 0/4/12
channelized
t1 1 cem-group 0 unframed
interface CEM 0/4/12
no shut
cem 0
xconnect 10.10.2.2 204 encapsulation mpls
exit

Verifying the CEM Configuration of Channelized T3/T1 Interfaces

Use the show run controller command to verify the CEM configuration of channelized T3/T1 interface:
# show run controller t3 0/4/12
Current configuration : 109 bytes
!
Controller T3 0/4/12
framing c-bit
cablelength short
t1 1 cem-group 0 unframed
end
Use the show cem circuit interface cem command to verify the CEM configuration of channelized T3/T1
interface:
# show cem circuit interface cem 0/4/12
CEM0/4/12, ID: 1, Line: UP, Admin: UP, Ckt: ACTIVE
Controller state: up, T1 state: up
Idle Pattern: 0xFF, Idle CAS: 0x8
Dejitter: 5 (In use: 0)
Payload Size: 192
Framing: Unframed
CEM Defects Set
None
Signalling: No CAS
RTP: No RTP
Ingress Pkts: 105043259 Dropped: 0
Egress Pkts: 105043387 Dropped: 0
CEM Counter Details
Input Errors: 0 Output Errors: 0
Pkts Missing: 0 Pkts Reordered: 0
Misorder Drops: 0 JitterBuf Underrun: 32
Error Sec: 0 Severly Errored Sec: 0
Unavailable Sec: 0 Failure Counts: 0
Pkts Malformed: 0 JitterBuf Overrun: 0
---
CEM0/4/12, ID: 28, Line: UP, Admin: UP, Ckt: ACTIVE
Controller state: up, T1 state: up
Idle Pattern: 0xFF, Idle CAS: 0x8
Dejitter: 5 (In use: 0)
Payload Size: 192
Framing: Unframed
CEM Defects Set
None
Signalling: No CAS
RTP: No RTP
Ingress Pkts: 136303 Dropped: 0
Egress Pkts: 0 Dropped: 0
CEM Counter Details
Input Errors: 0 Output Errors: 0
Pkts Missing: 135682 Pkts Reordered: 0
Misorder Drops: 0 JitterBuf Underrun: 137649
1 port OC48/ 4 port OC12/OC3 + 12 port T1/E1 + 4 port T3/E3 CEM Interface Module Configuration Guide, Cisco IOS
XE Fuji 16.7.x (Cisco ASR 900 Series)
27