Ip Igmp Snooping Multi-Vlan-Config - TP-Link T1600-28TS Cli Reference Manual

27.12

ip igmp snooping multi-vlan-config

Description
The ip igmp snooping multi-vlan-config command is used to create
Multicast VLAN. To delete the corresponding Multicast VLAN, please use no
ip igmp snooping multi-vlan-config command. To restore the default values,
please use no ip igmp snooping multi-vlan-config with specified
parameters.
Syntax
ip igmp snooping multi-vlan-config [
member-time
lagid
no ip igmp snooping multi-vlan-config [ rtime
member-time
lagid
Parameter
vlan-id
from 2 to 4094. If not specified, the default multicast VLAN will be selected.
router-time
receive IGMP query message from the router port, it will consider this port is
not a router port any more. Router Port Time ranges from 60 to 600 in
seconds. By default, it is 0 and the global router-time will be used.
member-time
receive IGMP report message from the member port, it will consider this port
is not a member port any more. Member Port Time ranges from 60 to 600 in
seconds. By default, it is 0 and the global member-time will be used.
port-list
lagid
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin level users have access to these commands.
Example
Enable Multicast VLAN 3, and configure Router Port Time as 100 seconds,
Member Port Time 100 seconds, and Static Router Port port 1/0/3:
| rport interface { gigabitEthernet
} ]
| rport interface { gigabitEthernet
} ]
—— The ID of the multicast VLAN desired to create or modify, ranging
—— Router Port Time. Within this time, if the switch does not
—— Member Port Time. Within this time, if the switch does not
—— The list of Ethernet ports.
—— The ID of the LAGs.
vlan-id
] [ rtime
237
router-time
| mtime
port-list
| port-channel
router-time
| mtime
port-list
| port-channel