SAFETY INTRODUCTION
1. Please read the safety operating introduction very carefully.
2. Please store this manual so that refers it again.
3. Before clean up the device by wet cloth, please confirm that power connector is
out of outlet, DO NOT use any liquid or decontamination spray to clean it up!
4. There must be a easy touched power outlet.
5. Please confirm that the device is be put on a stable platform before installation,
accident fall may cause damages of device.
6. Please confirm that the voltage which is come from power outlet is fit on the
requirement, before you connect the device to outlet.
7. Please arrange the power cable in a hiding place and do not cover anything on the
cable.
8. Please be cautious of the warnings and notices on the device.
9. If the device is not used for a long time, shut off the power to avoid the damages by
transient overvoltage.
10. DO NOT allow any liquid flow into the device so that cause fire or short circuit.
11. DO NOT pull the device up by yourself, please let any certificated engineer to do
that for your safety.
If you meet the following situations, please repair it by professional person:
Power cable or connector is broken;
Liquid flow into the device.
Device doesn't work properly. Or you can't make it work through the user manual.
This device falls or any damage;
Some obvious damage;
12. DO NOT store the device in out of the temperature range what we suggested, NOT
less then ‐30°C or higher than 70°C, or may damage the device.
TPC6000‐A2152 User Manual
4