Step 6: Insert the four monitor mounting screws provided in the wall mounting kit into the
four screw holes on the real panel of the flat panel PC and tighten until the screw
shank is secured against the rear panel
Step 7: Align the mounting screws on the monitor rear panel with the mounting holes on the
bracket.
Step 8: Carefully insert the screws through the holes and gently pull the monitor downwards
until the monitor rests securely in the slotted holes. And ensure that all four of the
mounting screws fit snuggly into their respective slotted holes.
Step 9: Secure the panel PC by fastening the retention screw of the wall‐mounting bracket.
2.6.4 Panel mounting
To mount the TPC6000‐A2152‐T flat panel PC into a panel (not standard attached), please
follow the steps below:
Step 1: Select the location on the panel to mount the flat panel PC.
Step 2: Cut out a section from the panel that corresponds to the rear panel dimensions of
the flat panel PC. Take care that the panel section that is cut out is smaller than the
overall size of the metal frame that surrounds the flat panel PC but just large
enough for the rear panel of the flat panel PC to fit through. Recommended cutout
size as shown below:
Figure 2‐10: TPC6000‐A2152‐T cut out.
Step 3: Slide the flat panel PC through the hole until the frame is flush against the panel.
TPC6000‐A2152 User Manual
22