Figure 2‐13: LAN connection
Step 3: Insert the LAN cable RJ‐45 connector. Once aligned, gently insert the LAN cable
RJ‐45 connector into the onboard RJ‐45 port.
2.7.2 Serial device connection
The serial device connectors are for connecting serial devices to the TPC6000‐A2152‐T.
Follow the steps below to connect a serial device to the TPC6000‐A2152‐T panel PC.
Step 1: Locate the DB‐9 connector. The location of the DB‐9 connector is shown in chapter
2.
Step 2: Insert the serial connector. Insert the DB‐9 connector of a serial device into the DB‐9
connector on bottom panel. Please see Figure 2‐14.
Figure 2‐14: Serial device connector
Step 3: Secure the connector. Secure the serial device connector to the external interface by
tightening the two retention screws on either side of the connector.
TPC6000‐A2152 User Manual
25