To install the TPC6000‐A2152‐T on the arm, follow the direction below:
Notice: Make sure the arm supports standard VESA mounting. The TPC6000‐A2152‐T uses a
VESA mounting to attach to the arm.
Step 1: The arm purchased separately, follow the instructions in the arm's user manual to
securely attach the arm to the wall.
Step 2: Once the mounting arm has been firmly attached to the surface, lift the flat panel PC
onto the interface pad of the mounting.
Step 3: Align the retention screw holes on the mounting arm interface with those in the flat
panel PC.
Step 4: Secure the flat panel PC to the interface pad by inserting four retention screws
through the bottom of the mounting arm interface pad and into the flat panel PC.
2.6.3 Wall mounting
To mount the flat panel PC onto the wall, please follow the steps below:
Figure 2‐9: Wall mount
Step 1: Select the location on the wall for the wall‐mounting bracket.
Step 2: Carefully mark the locations of the four bracket screw holes on the wall.
Step 3: Drill four pilot holes at the marked locations on the wall, for the bracket retention
screws.
Step 4: Align the wall‐mounting bracket screw holes with the pilot holes.
Step 5: Secure the mounting‐bracket to the wall by inserting the retention screws into the
four pilot holes and tightening them
TPC6000‐A2152 User Manual
21